SSC Touch 4 TIG Hand Control – Miller 14 Pin – T810-1425

The Only TIG Hand Control That Works Like a Foot Pedal

The Touch 4 fingertip control is a new approach to TIG welding amperage control. The idea is simple and innovative, and the result is a steady hand and simple control at your fingertips.

Instead of a knob that you have to turn or a slider that you have to move while trying to hold your TIG torch steady, the Touch 4 relies on pressure applied by your finger.

The Touch 4 works in steps: you apply pressure to turn on the contactor, giving you your low-amps setting, and then you increase pressure through 4 steps: 25%, 50%, 75%, and 100% of the setting on your panel. Set the amps on your panel to about 33% more than the suggested current for the thickness and metal type, and then you simply dither to create the puddle and weld that you want.

The Touch 4 works best for applications where you are normally at the full amperage set on your welder but occasionally need to back off the heat. Touch 4 is designed to work with almost any welder and can be used to replace Miller hand controls such as the RCCS-14 (043668) or RCC-14 (151086), 

Patented, designed, and made in the USA.

• Will not work on Miller EconoTIG. It allows on off but no amperage control when used on the EconoTIG.
• Will not work on Miller Diversion (165 or 180) or any Miller that uses the RJ45 plug (RFCS-RJ45)
• Made in USA
• Part Number: T810-1425

• Model:		T810-1425
  Cable Length:		25 ft. (7.62 m)
  Connection:		Miller 14-Pin Ampenol

  Product Data Sheet and More Information

  Title	Default Title